Christine Cox

Metalsmith: Twist to De-Bur
(another installment in a typically occasional series by Christine Cox)removebur-done

After drilling in metal there is often a large bur around the hole. It’s unsightly, dangerous and can throw off how your piece goes together. Eliminate it easily by using a drill bit that’s larger (by far) than the hole you’ve drilled. Chuck the large bit up into a pin vise. Place the metal, bur side up, onto a surface that allows the tip of the drill bit to drop down through the hole. I usually just place the hole over the V in my bench pin, or slide it off the edge of the bench, whichever is easiest. Press down firmly and twist to remove the bur. Caution, don’t go all the way through or you’ll be left with a hole much larger than you intended. Lightly twist back and forth a couple of additional times to clear the swarf and you’re done.

This is also a quick and dirty way to create a countersunk hole. Just push down a little harder as you twist to get the characteristic flared out edge around the hole.

removebur  removebur-dtl

Available from Volcano Arts:


Metal stock


Small pin vise

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Tag Cloud

%d bloggers like this: